Datacom Systems D56 Guía para resolver problemas descargar pdf (Pagina 76)

–76–

10 INPUT S/N: L

Axxx xxxx

5. This prompt is displayed when the system has found the next zone

which needs to be enrolled. The system will respond to the first serial

number transmitted after the [

✱

] key on the keypad is pressed. A

serial number may be enrolled by one of two methods:

a) Enter the 7 digit serial number printed on the transmitter

b) Activate the transmitter by faulting or restoring the input you

wish to use for that zone (e.g., press a button, open or close a door,

etc.).

If you do

not

wish to enroll the zone displayed, press the [#] key on the keypad

or the upper right-hand button on the program tool (a long beep will be heard to

verify). The following prompt will appear:

10 LEARN S/N?

0 = NO, 1 = YES 0

To enroll now, enter "1" (YES). If "0" (NO) is entered, the following prompt will

appear if a program tool has already been programmed:

E N T E R ZN NU M .

( 0 0 = Q U I T ) 1 2

Zone Number Entered ▲

Enter the next zone number to be enrolled (e.g., zone 12). The system will

search for that zone and will display the prompt shown in the beginning of step

5. If you wish to exit the enroll mode completely, enter 00 and press [

✱

10 INPUT S/N:L

A 022-4064 3

▲ ▲

Serial # Loop #

The system will enroll the serial number of the first transmitter

heard, add the loop number entered to this serial number, display the

serial and loop numbers, and cause the keypad to beep twice.

If the serial and loop number combination is already present in the system, a

single long beep will be heard from the keypad. If this happens, the system will

not display the serial number, but will wait for a transmission from another

transmitter or transmitter loop input.

6. The system will then enter an optional confirmation mode so that the

operation of the actual programmed input can be confirmed. Activate

the loop input or button that corresponds to this zone. We

recommend that you confirm the programming of every

transmitter before proceeding to the next zone.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 103 104

Comentarios a estos manuales

Sin comentarios

Datacom Systems D56 Guía para resolver problemas Pagina 76

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Datacom Systems D56