Datacom Systems D56 Guía para resolver problemas descargar pdf (Pagina 61)

–61–

Section 17. ZONE PROGRAMMING ( ✱56 Menu Mode)

While in program mode, press ✱

56 to enter Zone Programming

Menu Mode.

Refer to the zone assignment table for

✱

56 on the separate

programming form .

This is an interactive menu mode that is used to program zone

numbers, zone types, alarm and report codes, and to identify the type

of loop input device. This mode can also be used for "enrolling" 5800

series transmitter ID codes and for entering Alpha descriptors for

zones (we recommend entering descriptors in menu mode

✱

82).

NOTE: If using wireless transmitters, there are two methods for

enrolling the transmitter serial numbers. The first method is by

using *56 Zone Programming mode (described below). The second

method is by using *83 Sequential mode. Note that the ✱83

Sequential mode requires that all zone information first be entered

using ✱56 Zone Programming mode.

Program Tool: The Zone Programming and Sequential Modes allow

you to use a 5803 or 5804 button-type transmitter as a "program

tool." The upper left-hand and right-hand buttons of the tool

duplicate the [✱] and [#] keypad programming functions. The

advantage of using a program tool is that it enables remote

enrollment. You can move to the physical location of the transmitter

to be enrolled, press the upper left-hand button of the program tool,

and then trip the intended transmitter. The transmitter that you use

as the program tool can also be used as a transmitter in the system.

If you plan to use an existing transmitter, it must first be enrolled

into the system as its associated zones. You may then program it as

the tool.

After entering

✱

56, the following prompts are displayed:

If the system has been set up to use wireless transmitters, and a

program tool has been entered, skip to the zone number prompt. If no

program tool has been entered, the following prompt will appear:

PROGRAM TOOL?

0 = NO, 1 = YES 0

If a program tool (5803/5804) is being used, enter "1." If not using a

tool, enter "0" and skip to the zone number prompt.

00 INPUT S/N: L

A X X X–X X X X

If "1" is entered, the system will prompt for the serial number of the

transmitter being used as the program tool. You can enter the serial

number using one of the following methods:

a) Enter the 7-digit serial number for the transmitter

b) Press any button on the transmitter. The keypad should beep

twice and display the serial number of the tool.

00 INPUT S/N: L

A123-4567 3

In this example, the serial number is A123-4567. Once entered, you

can use the 5803/5804 program tool to ready the system for enrolling

a transmitter's serial number by first pressing the upper left-hand

button of the program tool, then activating the desired transmitter

(see procedure at the "enroll S/N?" prompt).

To back up to the "PROGRAM TOOL ?" prompt, press the [#] key on

the keypad.

The serial number for the program tool will only remain in

the system until the programming mode is exited. (Entering

✱

97 will not delete the tool.)

Press [

✱

] to continue.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 103 104

Comentarios a estos manuales

Sin comentarios

Datacom Systems D56 Guía para resolver problemas Pagina 61

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Datacom Systems D56